Whirlpool Water Heater High Temperature Shutdown Reset

Posted on

Whirlpool Water Heater High Temperature Shutdown Reset

Press the small reset button in the center of the thermal switch. If it’s tripped, you may be able to hear it click. Even if you do not hear the thermal switch click, try lighting the pilot using the instructions on the water heater’s label. If the Status Light now begins to flash, the thermal switch probably tripped.
We have no hot water, one year old hot water heater. Ours is flashing four times for high temperature shutdown. That said the error you mention is typically a one time failure that cannot be reset. Lowes and had them install it) you’ll probably have to call Whirlpool tomorrow for warranty service info.
My Whirlpool gas water heater is giving me the dreaded “four blinks” signal. that when you turn the dial to a normal, albeit high, position, it breaks the water heater?. Set the dial to a reasonable temperature that won’t upset the finicky little thing, and you. You will now need to restart the Pilot as before.
So how did water temperature inside tank go much above 170°?. I do not know if higher ECO threshold is the reason the new gas valve does have same problem. Also. according to the service manual on pg 5 and 21, 4 blinks can mean a failed gas control which Sears confirmed. How to light Whirlpool energy smart
My water heater uses the Honeywell WV840B1109 321166-000 Water Heater. You can reset the code by turning Gage all the way up highest setting count to. 4, which by the controller is “high temperature shutdown” and has. SOURCE: How to instal.

Leave a Reply

Your email address will not be published. Required fields are marked *