Whirlpool Washer Stuck On Sensor

Posted on

Whirlpool Washer Stuck On Sensor

Model: WTW4616FW. This washer was installed brand new today, and for the last two hours I’ve been trying to get it to function. It goes through the sensing cycle .
My washing machine is stuck with sensor light on and the motor keeps humming. I’ve unplug – Learn about GE – 3.8 Cu. Ft. 11-Cycle .
Top-load Whirlpool washing machine gets stuck on “sensing” stage of wash … We had the same problem with our washing machine being full of water … If the washer won’t finish a spin cycle, it probably means that your timer .
SENSING/FILL Light is on. When the Start/Stop button is pressed, and the Water Level knob is set to Auto Sensing, the washer will fill and begin .
Whirlpool WTW5000DW1 stuck sensing. Thread starter … After it stops the sensing light is still illuminating washer still filled with water.
Washer won’t go past sensing and lid lock light blinks? Appliance … It is Sears made by whirlpool. Thanks … We have a series 400 Kenmore washing machine.
I have a Whirlpool Cabrio washer about a year old. When I run a wash cycle it gets stuck in constant loop of wash cycles going on and on.
Probably a clogged pressure switch. Clean or replace. The pressure switch shuts off power to the water inlet valve when the proper water level .

Run Diagnostic Mode (DIY Video)

Try to run Diagnostic Mode by following step by step above, if there are any problems on your washing machine, it will tell you the error codes.

Leave a Reply

Your email address will not be published. Required fields are marked *