Whirlpool Washer Stuck On Sensing

Posted on

Whirlpool Washer Stuck On Sensing
My washing machine is stuck with sensor light on and the motor keeps humming. I’ve unplug – Learn about GE – 3.8 Cu. Ft. 11-Cycle .
I have a Whirlpool Cabrio washer about a year old. When I run a wash cycle it gets stuck in constant loop of wash cycles going on and on.
Washer won’t go past sensing and lid lock light blinks? Appliance … It is Sears made by whirlpool. Thanks … We have a series 400 Kenmore washing machine.
Top-load Whirlpool washing machine gets stuck on “sensing” stage of wash … We had the same problem with our washing machine being full of water … If the washer won’t finish a spin cycle, it probably means that your timer .
Call whirlpool or whoever your bought it from and get a warranty guy to come out and look at it, if you can’t even get it into diagnostic mode then chances are it’s a board problem. Before you call tho leave the machine unplugged for a good 15-20 minutes and try again.
After attempting this again I am noticing that after it goes through the sensing mode a couple of times and it wants to start up but it looks like it gets stuck because .
SOLVED: To those who may be searching for solutions here’s an update. We had someone come out and look at the washer and the issue was actually with the apartment’s cold water inlet. Just in case, the washer’s control board was replaced as well.

Leave a Reply

Your email address will not be published. Required fields are marked *