Whirlpool He Washer Stuck On Sensing

Posted on

Whirlpool He Washer Stuck On Sensing

If the lid is left open for more than 10 minutes, the washer will cancel the cycle and pump out the water. The lid will lock after the wash phase to begin the initial spinout and remain locked for the remainder of the cycle.
Whirlpool WTW5000DW1 stuck sensing. Thread starter … After it stops the sensing light is still illuminating washer still filled with water.
Whirlpool Cabrio Washer Stuck In Wash Loop – How To Reset …. He has 30 years of experience troubleshooting and repairing all types of .
Kenmore he washer. Not progressing out of sensing Model 110.26002011. Lid locks and unlocks. Then locks again. Drum spins several times .
Washer won’t go past sensing and lid lock light blinks? Appliance Repair Questions … What could be the problem with this 4 year old Sears He model 11026002010. It is obviously not the lid … It is Sears made by whirlpool. Thanks, Louis S.
Probably a clogged pressure switch. Clean or replace. The pressure switch shuts off power to the water inlet valve when the proper water level .
Our 6 month old HE clothes washer, model 28002, will start sensing, lock the top door, pause for about 5-10 seconds, and then unlock the top .
The following applies to top load washers that are equipped with the Hydrowave system (check model specifications for models that have the Hydrowave system.

Leave a Reply

Your email address will not be published. Required fields are marked *