Whirlpool Dishwasher Diagnostic Test Mode

Posted on

Whirlpool Dishwasher Diagnostic Test Mode

Press and hold the start button and turn it back on. Hold the start button in till the start light is flashing then let go. Now press the start button once and close the door. Now it will run a 12 minute test cycle.
Try the action below to run a diagnostic test on your dishwasher: 1 – Turn the dishwasher on. 2 – Press the rinse cycle button. 3 – Turn the dishwasher back off. 4 – Hold down the start button while you turn the dishwasher back to on. 5 – When the light starts flashing immediately let go of the start button.
Note: On some of the newer Whirlpool, Kenmore, KitchenAid dishwashers, you start the diagnostic cycle by rapidly pressing the 3 left-most keys .
here is a link which shows how to run a diagnostic program on a Whirlpool dishwasher. Hopefully it will work on yours. If it does and you get a .
You may see this error code appear if you have run a test cycle to diagnose your dishwasher. (To see how to run a test cycle, consult your appliance manual.
How do I run diagnostics on a new Whirlpool Dishwasher (Model: WDT790SAYM)?. Have a … It does not continue with the wash cycle.
This Service Manual, “18” & 24” ADA Built-In Dishwashers” (Part No. … to properly diagnose malfunctions and repair the “18” & 24” ADA .

Leave a Reply

Your email address will not be published. Required fields are marked *