Whirlpool Cabrio Washer Wont Lock And Start

Posted on

Whirlpool Cabrio Washer Wont Lock And Start

Whirlpool Washer door or lid won’t lock. Door Lock Motor and Switch Assembly. The door lock secures the washer door shut during operation. Door Latch. The door latch assembly might be defective. Door Lock. The door lock assembly might be defective. Door Strike. Inspect the door strike assembly for damage. Solution 5:

The 2 parts that can cause the Washer Not Spinning and Lid Lock Light Flashing on your Whirlpool Washer are: The ACTUATOR/SHIFTER and or the LID LOCK ASSEMBLY. – Check both of these parts visually and with a meter if needed.
Whirlpool Cabrio Washer Stuck In Wash Loop
If the washer lid or door won’t lock the lock and switch assembly might be defective. This is a very common problem. The lock and switch …
Problem: Washer lid locks but then unlocks so that cycles won’t begin. The lid latch/switch will not engage if it is dirty and is not making good contact to signal the washer to begin a cycle. Try unplugging the washer to allow the control panel to reset.
My Whirlpool washer’s lid isn’t locking and isn’t working because of that. … my own for yrs ,oh ,I beleive its your lid lock ,it will not do nothing until replaced ,mine was a real simple fix ,good luck … We turn it off and restart it.

Leave a Reply

Your email address will not be published. Required fields are marked *