Trane Thermostat Displays Wait

Posted on

Trane Thermostat Displays Wait

Each thermostat model has a different display message when a delay occurs. This delay can be up to five minutes under normal operating .
The “Wait” message on a Honeywell Thermostat means the thermostat is waiting to activate the HVAC system. This is done to prevent damaging the HVAC system compressor. If the system is working properly, then “Wait” should disappear after a few minutes. … A thermostat is a device that controls a building’s HVAC system.
Trane manufactures a line of thermostats designed to work with the heating … Wait five minutes after turning on the thermostat or selecting a new temperature setting. … after a five-minute delay if “Cool On” or “Heat On” flashes on the display .
The center plastic button, where this picture says, “pulls in with 24 volts” … a click, but the screen still says WAIT and inside fan is not turning on.
do you know what model number the thermostat is? … to confirm….the unit is running properly but WAIT or WAITING is present on thermostat?
We just had two brand new identical Trane XV18 units installed. … easier to see through photos, but basically the Thermostats display “waiting” .
Thermostat Troubleshooting – System Not Responding. When your … For the Honeywell 8000 series if “Wait” is displayed, the compressor protection timer is on.

Leave a Reply

Your email address will not be published. Required fields are marked *