Trane Hvac Thermostat Says Waiting

Posted on

Trane Hvac Thermostat Says Waiting

A delay is used to protect your heating and cooling equipment from coming on too quickly (known as short cycling), which can cause damage. The thermostat has a built-in compressor protection (minimum off timer) that prevents the compressor from restarting too early after a shutdown.
Your thermostat may not be set properly. Check to see if your thermostat is properly programmed to heat or cool your home depending on the season.
My trane thermostat says waiting, unsure. I have cool air blowing out, yes, System is 5 years old, regular service – Answered by a verified HVAC .
Thermostat: Trane – TCONT824AS52DA 824 STAT Humidifier: Trane – THUMD300 System goes in to the waiting state while heating. We we’re .
Trane manufactures a line of thermostats designed to work with the heating and cooling … check that the heat setting on the thermostat is higher than the room’s temperature. … Wait five minutes after turning on the thermostat or selecting a new .
The “Wait” message on a Honeywell Thermostat means the thermostat is waiting to activate the HVAC system. This is done to prevent .
Hello, I just had a new Trane heat pump and air handler installed with the Trane xl824 thermostat that is linked with Nexia. I have a question about the system .
honeywell programmable thermostat is controlling a combination heat pump/ furnace. It has been sitting at a ”wait” mode for 30 minutes.

Leave a Reply

Your email address will not be published. Required fields are marked *