Kenmore Water Heater High Temperature Shutdown

Posted on

Kenmore Water Heater High Temperature Shutdown

Found an item that talked about the unit may shut down because of the high temperature regulator system. It recommended we open the cover plate of the unit and push the “reset” button.
If the circuit board senses water temperature over 188-199°, then ECO error 4 should. hot water, then the water temperature inside tank did not go high enough to trip. My Kenmore water heater is controlled by the Honeywell Gas Valve (part.
If the water heater works for a while and then trips the high-temperature limit. gas supply provided to the water heater and check the gas supply shut-off valve to.
Read and follow water heater warnings and instructions. M Inlet Water Shut-off Valve. temperature no higher than 120°F, we recommend the installation.
heater. Status light @ 4 blinks between 3 seconds indicating “high temperature shutdown” even though lighting pilot with water cold.
My Whirlpool gas water heater is giving me the dreaded “four blinks” signal. you turn the dial to a normal, albeit high, position, it breaks the water heater?. Set the dial to a reasonable temperature that won’t upset the finicky little. My Kenmore water heater is controlled by the Honeywell Gas Valve (part.
The information on this web site is supplemental to the printed instructions that came with your water heater. To reduce the risk of property damage, serious injury.
PLEASE DO NOT CALL THE LOCAL NUMBER FOR KC WATER HEATER FOR. 4 – Replace Gas Valve If the temperature has exceeded the lim.

Leave a Reply

Your email address will not be published. Required fields are marked *