Honeywell Thermostat Recovery Wait

Posted on

Honeywell Thermostat Recovery Wait

Honeywellhome.com is moving to Resideo.com. …. My thermostat display shows “wait” or “waiting for equipment” or has a flashing “cool on” in … Each thermostat model has a different display message when a delay occurs.
With a typical thermostat when you set the temperature to be 70 degrees at … Some of the Honeywell models have a recovery mode where it will in theory … Rather than just waiting until 5:00 to reset the temperature setpoint
The “Wait” message on a Honeywell Thermostat means the thermostat is waiting to activate the HVAC system. This is done to prevent damaging the HVAC system compressor. If the system is working properly, then “Wait” should disappear after a few minutes. It will then resume normal operation.
But Honeywell thermostats are designed with state-of-the-art climate-control … but your Honeywell thermostat says “Wait” and doesn’t seem to be … the load on the heating or cooling system, and that’s the “Recovery” mode.
Recovery mode is when the thermostat turns on the heating/cooling ahead of time … have set, rather than dumbly waiting for 2:45 when you dont want the house to be … Honeywell TH4110D1007 Programmable Thermostat.
For the Honeywell 8000 series if “Wait” is displayed, the compressor protection timer is on. Wait 5 minutes for the system to safely restart. The compressor .
Heat Pumps and Electric Home Heating – Honeywell Thermostat says Wait – It has said “Wait” for awhile now. Tried and checked breakers.
When you set the thermostat fan switch to ON does the blower start/run? … it just starting this wait and followinf schedule thig on its own now its .

Leave a Reply

Your email address will not be published. Required fields are marked *