Honeywell Thermostat Not Working After Battery Change

Posted on

Honeywell Thermostat Not Working After Battery Change

Most thermostats only use the batteries to power the thermostat itself, LED display. to have an HVAC tech troubleshoot, and possibly replace the transformer.
If your Honeywell programmable thermostat flashes “Batt Lo,” you simply need to replace the battery. If the thermostat is malfunctioning and will not reset, simply cut the power to the thermostat and it will reset itself.
With a programmable thermostat, such as one made by Honeywell, you can program it to. Remove the batteries and put them back in the correct way, then close the battery door. Julius Vandersteen has been a freelance writer since 1999. His work has appeared in “The Los Angeles Times,” “Wired” and “S.F. Weekly.
If you change the batteries and the display shows o.k., but you have no heating, then you will have to decide what the problem is before throwing the thermostat.
Change the Batteries. A Honeywell thermostat will flash a low battery signal for about one to two months before the batteries in the wall unit run out completely. which means there may be a tripped breaker or a problem with the wiring.
Once you replace the batteries, you may need to reset the unit and reprogram your settings. If your thermostat doesn’t run on batteries and is wired directly to your home’s electrical system, a blank screen may indicate that there is no power going to the unit.
Honeywell thermostat flashing cool on after changing batteries. The A/C was not running when I changed the batteries. If a prog.

Leave a Reply

Your email address will not be published. Required fields are marked *