Freightliner Code Eec 61 3719

Posted on

Freightliner Code Eec 61 3719

NOTE: When this code is detected, the operator has two minutes to execute the entry conditions, cycle clutch switch (manual transmission).
Hi there . My name is ***** ***** Is it possible that the tubes are plugged going to the dpf pressure sensor ? Were those cleaned at the same .
high soot level code. … it should run the passive regen while driving. there was an issue with it to set the code. right now you are good to do.
Soot Level Very High NOTE: Do not interrupt regeneration once it has been initiated. NOTE: When this code is detected, the operator has two minutes to.
EEC 61 is basically saying there is a problem in the After-treatment control module. This is the module the Engine uses for the after treatment system. Your Check Engine Light, and/or your Maintenance light will be on at the same time.
SPN 3719/FMI 16 -. DDC-SVC-MAN- … NOTE: When this code is detected, the operator has two minutes to initiate regeneration request. … inactive fault code. 6.
Fault Code. Engine Power Rating. Recommended Action. Level 1: Engine. Warning g213866. Figure 1. Check Engine. SPN 3719, FMI 16.

Leave a Reply

Your email address will not be published. Required fields are marked *